硅酸盐学报

MnCO3掺杂对BMN陶瓷结构及介电性能的影响

作者：彭森1 2 3 吴孟强3 黄同成1 2 许建明1 2 罗高峰1 2 周建华1 2 余建坤1 2 张树人3

单位：1. 邵阳学院信息工程系湖南邵阳 422000 2. 邵阳学院湘西南农村信息化服务湖南省重点实验室湖南邵阳 422000 3. 电子科技大学能源科学与工程学院成都 611731

关键词：掺杂微波介质陶瓷介电性能

分类号：TM277

出版年,卷(期):页码：2017,45(3):339-345

DOI：

摘要：

采用固相烧结法，探讨了MnCO3掺杂降低Ba(Mg1/3Nb2/3)O3 (BMN)烧结温度的机理，研究了MnCO3掺杂量对BMN陶瓷微波介电性能的影响。结果表明，适量的MnCO3掺杂可以促进烧结，有效降低BMN陶瓷的烧结温度，改善陶瓷的微波介电性能。当MnCO3掺杂量为4%(质量分数)时，BMN陶瓷的烧结温度从纯相烧结时的1 550 ℃降低到1 250 ℃，表观密度 ρ = 6.36 g/cm3，相对理论密度达到98.6%，并具有良好的微波介电特性：高相对介电常数εr = 31.4，高品质因数与谐振频率的乘积Q·f =99 200 GHz (8 GHz)，接近于零的谐振频率温度系数τf = 3×10–7/℃。

MnCO3-doped Ba(Mg1/3Nb2/3)O3 (BMN) microwave dielectric ceramics were prepared via a solid-phase reaction sintering process. The effect of MnCO3-doped amount on the sintering temperature, microstructures and dielectric properties of BMN ceramics was investigated. The results indicate that MnCO3 addition can lower the sintering temperature of the ceramics and improve the microwave dielectric properties. When MnCO3 is 4%, the sintering temperature decreases from 1 550 to 1 250 ℃. The apparent density of MnCO3-doped BMN microwave dielectric ceramic is 6.36 g/cm3, the relative theoretical density is 98.6%. This ceramic possesses the superior microwave dielectric properties (i.e., high relative dielectric constant of 31.4, high quality factor plus resonant frequency of 99 200 GHz (8 GHz), and near-zero temperature coefficient of resonant frequency value of 3×10–7/℃.

基金项目：

国家自然科学基金(61135004)；湖南省自然科学基金(14JJ7075，15JJ2130)；湖南省教育厅基金(13A091，14A129，07C681)；湖南省高校科技创新团队支持计划资助。

作者简介：

彭森(1983—)，男，硕士，讲师。

参考文献：

[1] YUE Z X, SHI F, et al. Far-infrared reflection study on crystal structures and dielectric properties of Ba(Mg1/3Ta2/3)O3–BaWO4 ceramics[J]. J Mater Sci: Mater Electron, 2014, 26(2): 711–718.
[2] SHI F, DONG H L. Correlation of phonon characteristics and crystal structures of Ba[Zn1/3(Nb1–xTax)2/3]O3 solid solutions[J]. J Appl Phys, 2012, 111(1): 014111–01415.
[3] NOMURA S. Ceramics for microwave dielectric resonators [J]. Ferroelectrics, 1983, 49(1–4): 61–70.
[4] 董云飞, 李杨珍, 袁亮亮, 等. Ba1–3x/2Lax(Mg1/3Ta2/3)O3陶瓷的微波介电性能(Eng)[J]. 硅酸盐学报, 2008, 36(6): 739–747.
DONG Yunfei, LI Yangzhen, YUAN Liangliang, et al. J Chin Ceram Soc, 2008, 36(6): 739–747.
[5] CHEN F L, HONG H L, et al. Microstructural characteristics and microwave dielectric properties of Ba[Mg1/3(Nbx/4Ta(4–x)/4)2/3]O3 ceramics[J]. J Alloys Compd, 2006, 407(1–2): 318–325.
[6] LIU H X., TIAN Z Q. New microwave dielectric ceramics with near-zero τf in the Ba(Mg1/3Nb2/3)O3–Ba(Ni1/3Nb2/3)O3 system[J]. J Mater Sci, 2004, 39(13): 4319–4320.
[7] LIM J B,SON J, NAHM S, LEE W S, YOO M J. Low-temperature sintering of B2O3-added Ba(Mg1/3Nb2/3)O3 ceramics[J]. Jpn J Appl Phys, 2004, 43(8R): 5388–5391.
[8] 王冬梅, 毛宏, 吴孟强, 等. Ca–B–Si掺杂对Ba(Mgl/3Nb2/3)O3陶瓷介电性能的影响[J]. 电子元件与材料, 2010, 29(1): 22–24.
WANG Dongmei, MAO Hong, WU Mengqiang, et al. Electron Compon Mater(in Chinese), 2010, 29(1): 22–24.
[9] SUN T L, CHEN X M. Raman spectra analysis for Ba[(Mg1–xNix)1/3Nb2/3]O3 microwave dielectric ceramics[J]. AIP Adv, 2015, 5(1): 3–26.
[10] DESU S B, O'BRYAN H M. Microwave loss quality of BZT ceramics[J]. J Am Ceram Soc, 1985, 68(10): 546–551.
[11] DIAO C L, WANG C H, et al. First-principle calculation and assignment for vibrational spectra of Ba(Mg1/3Nb2/3)O3 microwave dielectric ceramic[J]. J Appl Phys, 2014, 115(11): 114103–114112.
[12] 彭森, 吴孟强, 肖勇, 等. SrCO3掺杂对 BMT 陶瓷结构及介电性能的影响[J]. 硅酸盐学报, 2011, 39(12): 1947–1952.
PENG Sen, WU Mengqiang, XIAO Yong, et al. J Chin Ceram Soc, 2011, 39(12): 1947–1952.
[13] YU S Q, TANG B, ZHANG X, ZHANG S R, ZHOU X H. Improved high-q microwave dielectric ceramics in CuO-doped BaTi4O9–BaZn2Ti4O11 system[J]. J Am Ceram Soc, 2012, 95(6): 1939–1943.
[14] TANG B, FANG Z X, LI Y X, ZHANG X, ZHANG S R. Microwave dielectric properties of Ba(Co0.56Y0.04Zn0.35)1/3Nb2/3+xO3(x = −0.004~0.008) ceramics[J]. J Mater Sci: Mater Electron, 2015, 26(9): 6585–6591.
[15] DAI Y, ZHAO G, LIU H. First-principles study of the dielectric properties of Ba(Zn1/3Nb2/3)O3 and Ba(Mg1/3Nb2/3)O3[J]. J Appl Phys, 2009, 105(3): 034111–034119.
[16] WANG C H, JING X P, et al. XRD and Raman studies on the ordering/disordering of Ba(Mg1/3Ta2/3)O3[J]. J Am Ceram Soc. 2009, 92(7): 1547–1551.
[17] ZHANG H, DIAO C, et al. XRD and Raman study on crystal structures and dielectric properties of Ba[Mg(1−x)/3ZrxNb2(1−x)/3]O3 solid solutions[J]. Ceram Int, 2014, 40(1): 2427–2434.
[18] DONG H L, SHI F. Vibration spectra and structural characteristics of Ba[(Zn1−xMgx)1/3Nb2/3]O3 solid solutions[J]. Appl Spectrosc Rev, 2011, 46(3): 207–221.
[19] NING P F, LI L X, et al. Raman scattering, electronic structure and microwave dielectric properties of Ba([Mg1–xZnx]1/3Ta2/3)O3 ceramics[J]. Ceram Int, 2012, 38(2): 1391–1398.
[20] SHAN L,PAN W. Effect of V2O5 addition on the microwave dielectric properties of Ba(Mg1/3Nb2/3)O3 ceramics[J]. Key Eng Mater, 2007, 336(2): 301–303.
[21] 田中青, 张春艳, 余洪滔, 等. (1–x)Ba(Mg1/3Nb2/3)O3–xBaSnO3陶瓷的微波介电性能(Eng)[J]. 硅酸盐学报, 2008, 36(3): 283–287.
TIAN Zhongqing, ZHANG Chunyan, YU Hongtao, et al. J Chin Ceram Soc, 2008, 36(3): 283–287.

服务与反馈：

【文章下载】【加入收藏】